97 crv fm works fine but the am frequencies are very faint. any ideas?

 

On Mon, 16 Jun 2008 13:34:51 -0700, bigjcw1023 wrote:

> 97 crv fm works fine but the am frequencies are very faint. any ideas?

Turn the **** marked "Volume" in the clockwise direction.


--
"Bother!" said Pooh, as a vole stole his honey

 

On Jun 16, 9:50 pm, Dan C <youmustbejok...@lan.invalid> wrote:
> On Mon, 16 Jun 2008 13:34:51 -0700, bigjcw1023 wrote:
> > 97 crv fm works fine but the am frequencies are very faint. any ideas?
>
> Turn the **** marked "Volume" in the clockwise direction.
>
> --
> "Bother!" said Pooh, as a vole stole his honey

That is not the problem. FM comes in loud and clear AM vol has to be
way up for any station.

 

bigjcw1023@gmail.com wrote:
> On Jun 16, 9:50 pm, Dan C <youmustbejok...@lan.invalid> wrote:
>> On Mon, 16 Jun 2008 13:34:51 -0700, bigjcw1023 wrote:
>>> 97 crv fm works fine but the am frequencies are very faint. any ideas?
>> Turn the **** marked "Volume" in the clockwise direction.
>>
>> --
>> "Bother!" said Pooh, as a vole stole his honey
>
> That is not the problem. FM comes in loud and clear AM vol has to be
> way up for any station.

Drive closer to the AM station's tower.

a

 

<bigjcw1023@gmail.com> wrote in message
news:5b8381ac-32af-4a3c-af06-a7c2d261f82d@e53g2000hsa.googlegroups.com...
> 97 crv fm works fine but the am frequencies are very faint. any ideas?

Poor AM reception is usually an indication of an antenna problem. Could be a
ppor connection at the radio, a cable that has absorbed water, a poor ground
at the outside mount, a broken cable, etc. Chances are a new antenna and
cable will improve things (assuming it is not an internal radio problem).

Ed

 

On Jun 17, 9:56 am, a <a...@a.ca> wrote:
> bigjcw1...@gmail.com wrote:
> > On Jun 16, 9:50 pm, Dan C <youmustbejok...@lan.invalid> wrote:
> >> On Mon, 16 Jun 2008 13:34:51 -0700, bigjcw1023 wrote:
> >>> 97 crv fm works fine but the am frequencies are very faint. any ideas?
> >> Turn the **** marked "Volume" in the clockwise direction.
>
> >> --
> >> "Bother!" said Pooh, as a vole stole his honey
>
> > That is not the problem. FM comes in loud and clear AM vol has to be
> > way up for any station.
>
> Drive closer to the AM station's tower.
>
> a

well thanks for nothin guys. all of this is common sense crap.

 

"C. E. White" wrote

> Poor AM reception is usually an indication of an antenna problem. Could be
> a ppor connection at the radio, a cable that has absorbed water, a poor
> ground at the outside mount, a broken cable, etc. Chances are a new
> antenna and cable will improve things (assuming it is not an internal
> radio problem).

If the AM antenna is one separate from the FM, and into its own jack into
the radio, that sounds likely. The OP said FM works fine. But since it's one
antenna working well on FM, then no, I don't think that's the solution.
HOWEVER... ;-) If it were my car I would reach back behind the radio and
jiggle the connector to see if something's come loose. If there is no
change, then it may very well be an internal radio problem. I'd bang on it
gently to see if the reception improves even momentarily.

 

On Tue, 17 Jun 2008 13:44:04 -0700, bigjcw1023 wrote:

>> >> Turn the **** marked "Volume" in the clockwise direction.

>> > That is not the problem. FM comes in loud and clear AM vol has to be
>> > way up for any station.

>> Drive closer to the AM station's tower.

> well thanks for nothin guys. all of this is common sense crap.

No problem. Would you like your money back?


--
"Bother!" said Pooh, as Piglet stepped on the land mine.

 

"Howard Lester" <heylester@dakotacom.net> wrote in message
news:9ZGdnRKqKOITwsXVnZ2dnUVZ_vOdnZ2d@posted.dakot acomip...
> "C. E. White" wrote
>
>> Poor AM reception is usually an indication of an antenna problem. Could
>> be a ppor connection at the radio, a cable that has absorbed water, a
>> poor ground at the outside mount, a broken cable, etc. Chances are a new
>> antenna and cable will improve things (assuming it is not an internal
>> radio problem).
>
> If the AM antenna is one separate from the FM, and into its own jack into
> the radio, that sounds likely. The OP said FM works fine. But since it's
> one antenna working well on FM, then no, I don't think that's the
> solution. HOWEVER... ;-) If it were my car I would reach back behind the
> radio and jiggle the connector to see if something's come loose. If there
> is no change, then it may very well be an internal radio problem. I'd bang
> on it gently to see if the reception improves even momentarily.

AM reception is much more dependent on a good antenna than FM. A broken
antenna cable can actually make a decent FM antenna while providing poor AM
reception. I've had lots of practice with these sort of problems on my farm
tractors. I mostly listen to FM, but sometimes a sports even is only on an
AM station. More than once I've had to clean the outside ground connection
in order to pull in the AM signal. I've never had a problem with the FM
signal.

Ed

 

"C. E. White" wrote

> AM reception is much more dependent on a good antenna than FM. A broken
> antenna cable can actually make a decent FM antenna while providing poor
> AM reception. I've had lots of practice with these sort of problems on my
> farm tractors. I mostly listen to FM, but sometimes a sports even is only
> on an AM station. More than once I've had to clean the outside ground
> connection in order to pull in the AM signal. I've never had a problem
> with the FM signal.

Well, you're right. I was initially thinking of a broken connector at the
antenna jack. Of course, then he'd get no reception at all. It can get a
little tricky depending on where a cable might be broken (if it is) and
we're just speculating anyway. Jiggling the wire while it's connected to the
radio, and/or pulling out the connector and just touching the center tip to
the center of the jack is also part of the diagnosis. If there's a
bad/shorted ground, doing the latter should give an improved signal.

 

On Jun 18, 10:44 pm, "Howard Lester" <heyles...@dakotacom.net> wrote:
> "C. E. White" wrote
>
> > AM reception is much more dependent on a good antenna than FM. A broken
> > antenna cable can actually make a decent FM antenna while providing poor
> > AM reception. I've had lots of practice with these sort of problems on my
> > farm tractors. I mostly listen to FM, but sometimes a sports even is only
> > on an AM station. More than once I've had to clean the outside ground
> > connection in order to pull in the AM signal. I've never had a problem
> > with the FM signal.
>
> Well, you're right. I was initially thinking of a broken connector at the
> antenna jack. Of course, then he'd get no reception at all. It can get a
> little tricky depending on where a cable might be broken (if it is) and
> we're just speculating anyway. Jiggling the wire while it's connected to the
> radio, and/or pulling out the connector and just touching the center tip to
> the center of the jack is also part of the diagnosis. If there's a
> bad/shorted ground, doing the latter should give an improved signal.

has to be something. I got in the car this morning and it worked
fine. About an hour later same situation arose.

 

On Wed, 18 Jun 2008 19:49:06 -0700, bigjcw1023 wrote:

>> Well, you're right. I was initially thinking of a broken connector at the
>> antenna jack. Of course, then he'd get no reception at all. It can get a
>> little tricky depending on where a cable might be broken (if it is) and
>> we're just speculating anyway. Jiggling the wire while it's connected to the
>> radio, and/or pulling out the connector and just touching the center tip to
>> the center of the jack is also part of the diagnosis. If there's a
>> bad/shorted ground, doing the latter should give an improved signal.

> has to be something. I got in the car this morning and it worked
> fine. About an hour later same situation arose.

Are you even reading the replies you get? How about the one you just
quoted, above? It's almost certainly a bad antenna/wire/connector.
Figure it out and fix it. Sheesh.


--
"Bother!" said Pooh, as the antimatter containment vessel ruptured.

 

On Jun 19, 9:31 am, Dan C <youmustbejok...@lan.invalid> wrote:
> On Wed, 18 Jun 2008 19:49:06 -0700, bigjcw1023 wrote:
> >> Well, you're right. I was initially thinking of a broken connector at the
> >> antenna jack. Of course, then he'd get no reception at all. It can get a
> >> little tricky depending on where a cable might be broken (if it is) and
> >> we're just speculating anyway. Jiggling the wire while it's connected to the
> >> radio, and/or pulling out the connector and just touching the center tip to
> >> the center of the jack is also part of the diagnosis. If there's a
> >> bad/shorted ground, doing the latter should give an improved signal.
> > has to be something. I got in the car this morning and it worked
> > fine. About an hour later same situation arose.
>
> Are you even reading the replies you get? How about the one you just
> quoted, above? It's almost certainly a bad antenna/wire/connector.
> Figure it out and fix it. Sheesh.
>
> --
> "Bother!" said Pooh, as the antimatter containment vessel ruptured.

go suck canal water, just lettin people know whats going on. if you
aint got nothin better to do than dont bother

 

<bigjcw1023@gmail.com> wrote in message
news:ab1edb3b-800f-430b-9e7c-20006bf87887@8g2000hse.googlegroups.com...
> On Jun 19, 9:31 am, Dan C <youmustbejok...@lan.invalid> wrote:
>> On Wed, 18 Jun 2008 19:49:06 -0700, bigjcw1023 wrote:
>> >> Well, you're right. I was initially thinking of a broken
>> >> connector at the
>> >> antenna jack. Of course, then he'd get no reception at all. It
>> >> can get a
>> >> little tricky depending on where a cable might be broken (if it
>> >> is) and
>> >> we're just speculating anyway. Jiggling the wire while it's
>> >> connected to the
>> >> radio, and/or pulling out the connector and just touching the
>> >> center tip to
>> >> the center of the jack is also part of the diagnosis. If there's
>> >> a
>> >> bad/shorted ground, doing the latter should give an improved
>> >> signal.
>> > has to be something. I got in the car this morning and it worked
>> > fine. About an hour later same situation arose.
>>
>> Are you even reading the replies you get? How about the one you
>> just
>> quoted, above? It's almost certainly a bad antenna/wire/connector.
>> Figure it out and fix it. Sheesh.
>>
>> --
>> "Bother!" said Pooh, as the antimatter containment vessel ruptured.
>
> go suck canal water, just lettin people know whats going on. if you
> aint got nothin better to do than dont bother

Posting to this newsgroup is not a magic bullet. While you will get
some good direction here, it does not absolve you from helping
yourself. Start by learning more about AM radio signals, what they
are and how they propagate. See if the problem truly is random, or
does it have any type of pattern, then try to clearly articulate the
problem.

We have no way of originally knowing if it used to work, what type of
terrain, how far you are from the transmitter, and how many stations
are affected (all or some). The better the description of the
problem, the more likely you will get some meaningful help.

 

On Mon, 16 Jun 2008 13:34:51 -0700 (PDT), bigjcw1023@gmail.com wrote:

>97 crv fm works fine but the am frequencies are very faint. any ideas?


Any cell phone chargers plugged in? That would cause interference.
Doesnt effect FM, but can effect some AM.