Rep Power: 819

I got it a while ago but forgot i could put a review for it. The bar looks great under my car, and helped out the handling of the rear end a lot.( I replaced the shocks at the same time if that makes any difference.) for pics just check out my suspension page on cardomain.

 
Rep Power: 0

Nice I think when i order rear shocks next week
Ill throw in a few little things like the PHB and Poly kit

how hard was it to install everything? what was needed?

 
Rep Power: 716

Replacing the Panhard Bar is one of the easiest things you can do to your car. Changing all that stuff at the same time is always a good idea if you can afford to do it. But just changing a PHB alone you won't notice any difference at all. Swapping out the shocks and installing polyurathane bushings should make enough of a difference to notice an improvement.

 
Rep Power: 819

I was one of the easiest things i have done. You have to lift up the back carpet to get to where the shocks mount just so you know. The panhard bar would have taken like 5 minutes but I had to cut one of the old bolts off. All I needed was my air compressor and an impact wrench.

 
Rep Power: 0

nice

 
Rep Power: 684

Good to see you like it

Ryan

 
Rep Power: 718

i had a heck of a time getting out the passanger side bolt on the panhard bar. it had rusted to the sleeve in the bar.

 
Rep Power: 819

i did too so i just cut it off...old thread by the way