Twin engine cutlass
#1
#2
What a POS, a ****ing twin engine car, total displacement is 6.2 liters 12 cylinders, 310hp and 370 lb/ft, and it runs only 14???? ha ha , what a waste of money, an old mustang with minor mods will run 14. and total cost for a car and mods will be 00 times less than this car.
#3
actually i think his best et was a 13.8
front engine STOCK 3.1L 150HP give or take
REAR STOCK 3.8L 165HP.
with a trand total of 315hp... running 13s its prolly dead on. On top of which the project was made from misc GM parts so the swap was cheap and done well. ALSO since he has already mounted the rear engine a L67 front and back swap could be done easily. That should pull some serious numbers!
front engine STOCK 3.1L 150HP give or take
REAR STOCK 3.8L 165HP.
with a trand total of 315hp... running 13s its prolly dead on. On top of which the project was made from misc GM parts so the swap was cheap and done well. ALSO since he has already mounted the rear engine a L67 front and back swap could be done easily. That should pull some serious numbers!
#7
waste of money, waste of time...
cost him more in time to do that than if he had of gone and bought a 88 5L mustang, added a gear and nitrous and would have been hella faster...
What was this guy thinking
thing looks like it popped out of Unique Whips
cost him more in time to do that than if he had of gone and bought a 88 5L mustang, added a gear and nitrous and would have been hella faster...
What was this guy thinking
thing looks like it popped out of Unique Whips
#9
Originally Posted by 2TONE_93GT
waste of money, waste of time...
cost him more in time to do that than if he had of gone and bought a 88 5L mustang, added a gear and nitrous and would have been hella faster...
What was this guy thinking
thing looks like it popped out of Unique Whips
cost him more in time to do that than if he had of gone and bought a 88 5L mustang, added a gear and nitrous and would have been hella faster...
What was this guy thinking
thing looks like it popped out of Unique Whips
but thats just me
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)