Rep Power: 678

SO if you can read my...noobish paint pictures lol. I installed a trans kit, i placed the C-ring (C-clamp) whatever you wanna call it down the middle, cocked to the right. there was so much pressure it popped the c-clamp out of place. (i think thats what broke the metal, the pressure was on a weak point.) So what do you think i should do with this mess? I really don't want to swap trans housings...to much time and effort. I figured putting the c-clamp upside down (so the opening is up) and if there is a leak, which i do not think is the problem JB weld it. when the c-clamp is in...the servo and piston are inside the housing, we are talking about the 1/4-1/2 inch lip that comes out of the trans. It's just an ear off...its almost time to run outside and ghetto rigg this efffffin thing...hopefully it will work...im just looking for some advice if my way doesn't work... BTW the little peice that snapped off...is no where to be found...i wanna say it was lost a mile or so from my house because thats when i started smelling ATF. I'm lucky the c-clamp didn't get lost ither. Thanks for reading...any useful advice will be considered if my G-H-E-T-T-O rigg up won't work.