Just throwing this out there...
#1
Just throwing this out there...
I have a `94 Z28, Black in color, auto. Original everything except stereo (dual XDM7700) and speakers which are kenwood 6.5's 250 watts in front 170's in back.
Just had all MAJOR problems fixed which came 1400$ of work. Motor runs fine and the tranny shifts hard into drive and shifts hard out of first. Also needs an alignment but before that it need a lower ball joint and tie rod (about 408$ at Midas). And it needs new front rotors (warped) but it brakes fine just a bit shaky.
The body is straight and has a little bit of clearcoat peeling ( not HORRIBLE). The drivers left seat bolster is ripped. and there are two or three cracks on the top dash panel. It has a flow master muffler and newer Fuzion ZRi's all the way around. Rear brakes just done with new rotors and pads.
The drivers side door needs a bit of work. It needs a new hinge pin and something with the window tracks or mounts.
The car runs and drives fine except for pulling slightly to the right and vibrating when stopping from say 55+mph.
If you are interested just throw me an offer..I can get pics if interested..
Just had all MAJOR problems fixed which came 1400$ of work. Motor runs fine and the tranny shifts hard into drive and shifts hard out of first. Also needs an alignment but before that it need a lower ball joint and tie rod (about 408$ at Midas). And it needs new front rotors (warped) but it brakes fine just a bit shaky.
The body is straight and has a little bit of clearcoat peeling ( not HORRIBLE). The drivers left seat bolster is ripped. and there are two or three cracks on the top dash panel. It has a flow master muffler and newer Fuzion ZRi's all the way around. Rear brakes just done with new rotors and pads.
The drivers side door needs a bit of work. It needs a new hinge pin and something with the window tracks or mounts.
The car runs and drives fine except for pulling slightly to the right and vibrating when stopping from say 55+mph.
If you are interested just throw me an offer..I can get pics if interested..
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)