FS: 1993 240sx /w SR20DET
#1
FS: 1993 240sx /w SR20DET
For sale is my green 1993 240sx with 190xxxKM
Thanks To Tunerzine for the above pic
So far the car does 12.8 @ 113MPH. Best MPH is 117. The car makes just about 400HP @ 20PSI with lots of room!
Exterior
-Car was never winter driven and it was under oiled so there is NO rust in the frame!
-Has dime dents and a mark on the hood the size of a pop can!!
-Kouki 180sx Tail Lights
-D2 Coil Overs 5Kg in rear 7Kg in front
-Rear Upper Control Arms
-Aluminum Sub-Frame collors (not installed)
-300zx Brake Conversion /w SS Lines
-16" RS-Watanabe Wheels w/ Toyo T1R's 205/50/16 F and 245/45/16 R
Engine
-SR20DET Red Top w/ Stock Bottom End
-Fully Built, Port and Polished Cylinder Head w/ HKS Valve Springs, Crower Titanium Retainers, HKS 272 Step 2 Cams, GReddy Rocker Arm Stoppers.
-ARP Head Studs
-Cometic Metal Head Gasket
-GReddy Copy Intake Manifold
-HKS Fuel Rail
-780cc Injectors
-255 LPH Fuel Pump w/ 8 Gauge Rewire on a Seperate Relay
-Apexi Safc
-Full Race Copy Turbo Header
-Garret GT 35R Turbo
-TiAL 38mm Waste Gate
-3" Downpipe
-Excel Tuning 3" Stainless Exhaust
-12 x 3 x 24 Intercooler with 2.5" Cold Pipe and 3" Hot Pipe /w T-Bolt clamps
-300zx Blow Through MAF
-ACT Stage 3 Clutch
Interior
-Stereo Head unit is not installed
-Front Seats are worn
-Dash has Cracks in it from when car was broken in to
-Boost, EGT, Oil (Pressure Sensor is broken) and Water Temp Gauges Mounted on Dash
-Steering Wheel has Wear on the Top
-Alpine 4x6 in the doors and mids
-HKS EVC 4 Boost Controller
-JDM Gauge Cluster
Also lots of extra parts included if you want them ie, stock wheels, turbo manifold, o2 pipe, 3" stainless downpipe (for stock turbo setups), SR cylinder heads, starter, alternators, etc, etc.
11000 or B.O. Located in Guelph
PM me
Thanks To Tunerzine for the above pic
So far the car does 12.8 @ 113MPH. Best MPH is 117. The car makes just about 400HP @ 20PSI with lots of room!
Exterior
-Car was never winter driven and it was under oiled so there is NO rust in the frame!
-Has dime dents and a mark on the hood the size of a pop can!!
-Kouki 180sx Tail Lights
-D2 Coil Overs 5Kg in rear 7Kg in front
-Rear Upper Control Arms
-Aluminum Sub-Frame collors (not installed)
-300zx Brake Conversion /w SS Lines
-16" RS-Watanabe Wheels w/ Toyo T1R's 205/50/16 F and 245/45/16 R
Engine
-SR20DET Red Top w/ Stock Bottom End
-Fully Built, Port and Polished Cylinder Head w/ HKS Valve Springs, Crower Titanium Retainers, HKS 272 Step 2 Cams, GReddy Rocker Arm Stoppers.
-ARP Head Studs
-Cometic Metal Head Gasket
-GReddy Copy Intake Manifold
-HKS Fuel Rail
-780cc Injectors
-255 LPH Fuel Pump w/ 8 Gauge Rewire on a Seperate Relay
-Apexi Safc
-Full Race Copy Turbo Header
-Garret GT 35R Turbo
-TiAL 38mm Waste Gate
-3" Downpipe
-Excel Tuning 3" Stainless Exhaust
-12 x 3 x 24 Intercooler with 2.5" Cold Pipe and 3" Hot Pipe /w T-Bolt clamps
-300zx Blow Through MAF
-ACT Stage 3 Clutch
Interior
-Stereo Head unit is not installed
-Front Seats are worn
-Dash has Cracks in it from when car was broken in to
-Boost, EGT, Oil (Pressure Sensor is broken) and Water Temp Gauges Mounted on Dash
-Steering Wheel has Wear on the Top
-Alpine 4x6 in the doors and mids
-HKS EVC 4 Boost Controller
-JDM Gauge Cluster
Also lots of extra parts included if you want them ie, stock wheels, turbo manifold, o2 pipe, 3" stainless downpipe (for stock turbo setups), SR cylinder heads, starter, alternators, etc, etc.
11000 or B.O. Located in Guelph
PM me
Last edited by jdmpb; 06-29-2006 at 05:53 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)