Rep Power: 727

I'm selling my engine, i've put 40,000 kms on it since i've owned it (mileage before that is unknown b/c i got it from an importer). I put a new timing belt and water pump on it shortly after i got it. And just put a new timing belt on it about 500kms ago.
Its a second gen b16. The head has been ported and polished, has a 3 angle valve job and has been milled .030" and new honda valve seals, all work was done by Gord Bush Performance.

It has crane stage 2 cams, crane dual valve springs and titanium retainers, ferria valve locks, Venom adjustable cam gears, the valve cover has been cut to access the gears, and aftermarket cam seal. The block has ARP head studs doesn't burn any oil and runs mint.

The engine is still in my car so you can see how well it runs. I will include the chip i made on the dyno when it made 167.7whp (i have the dyno sheet to prove it). I can provide a chipped p28 with my dyno tuned program in it for an additional $100.

I am asking $1500 for just the head (no dizzy b/c its hard wired into my wiring harness or exhaust manifold or fuel rail) with everything but what i've mentioned included. Or $1700 for the head and block (assembled).

I would accept a trade plus cash for a b20.

I have pics, but if you know what an engine looks like, you know what this one looks like. You can come see it run. But please no tire kickers, serious buyers only.

I also have:
front mount intercooler (mounted but never used)
25" x 9" x 2.5"......$250

Brand new sealed in package 550cc peak and hold injectors with clips and i'll toss in a resistor box.....$225.

Chipped p28 with xenocron USB datalogging cable (setup to datalog with cromepro, ecu control, digital dash)...$225.

Deltagate waste gate with 2 springs (that equal 15psi you can remove one for less psi), i must tell you that it spikes at 15psi up a few psi so be careful....$100 obo.

Brand new Obd2a-obd1 ecu conversion harness.....$120

Located in hamilton
PM me or email....z_manith@hotmail.com
Or call
905-578-5707
Andrew

up up up